The Main Causes Of PCBA Phenomenon And Corresponding Countermeasures

- Jun 15, 2017 -

  The Main Causes of PCBA Phenomenon and Corresponding Countermeasures.

  Cause 1: nozzle problems, such as nozzle deformation, clogging, damage caused by insufficient pressure, leakage, resulting in suction can not afford, take material is not correct, but PCBA throwing material.

  Action: Clean the nozzle.

  Reason 2: Feeder problem, the feeder is not set, the location of deformation, poor feeding mechanism caused by reclaimed or poor data acquisition and PCBA throwing.

  Action: Reset the feeder, clean the equipment, calibrate or replace the feeder.

  Reason 3: identify the system problems, poor vision, visual or laser lens is not clean, foreign matter interference recognition, identify light source selection or strength, gray scale is not enough, there may be identification system has been bad.

  Action: Clean the wipe to identify the surface of the system, keep clean without foreign matter, oil pollution, etc., adjust the light intensity, PCBA grayscale, replace the identification system components.

Previous: What Are The Special Requirements For Varistor In PCBA Design? Next: PCBA Circuit Board And Components Of The Cleaning Method

Related News

Related Products

  • 50W Flood Light Pcb 2835 Leds
  • T8 24S2P Tube Mcpcb 2835leds
  • 1W 3W smd led chip aluminum pcb
  • 5W 7W 9W 12W Bulb Light Round PCB Board SMD2835 5630 LED Bulb pcb
  • China Mankun Street Light Aluminum Pcb With 24 3535leds Printed Circuit Board
  • rgb led pcb board single side pcb 5050 for led lights